
Product Information |
||
| pds | ||
| msds | ||
| label | ||
| sell sheet | ||
| spray setings | ||
Product Testing |
||
| Fire Rating | ||
| Performance Testing | Fed. Spec. TT-P-1411-A |
|
Fed. Spec. TT-C-555B |
||
| Water Pressure Retention | 20 lbs per inch2 |
|
| Water Vapor Permeance | 4.08 perms |
|
Product Specifications |
||
| Solids by Weight ± 2% | 67.0% |
|
| Solids by Volume ± 2% | 49.0% |
|
| Viscosity at 70° F | 125-135 Kreb Units |
|
| Flash Point: | Non-combustible |
|
| Shelf Life | 36 Months Min. |
|
(Original Sealed Container) |
||
| Calculated VOC: | <100 grams/liter |
|
| Coverage: | ||
| Smooth Surfaces: | 100-125 ft2/gal |
|
| Porous Surfaces: | 75-100 ft2/gal |
|
Drying Times (@ 70-77° F, 50% R.H) |
||
| To Touch: | 1 hour |
|
| To Recoat: | 3 Hours |
|
| Minimum Application Temp: | 50°F (10° C) |
|
| Package Sizes | ||
| 5 Gallon | ||
| Weight Per Gallon | 10 lbs/gal |
|
| Part Numbers | ||
| 5 Gallon | 8395 |
|
IAQ 9000 is a low-odor, waterproofing coating that is specially formulated to stop water from penetrating through a variety of interior and exterior surfaces including above or below grade masonry walls, cinder and concrete blocks, stucco, brick, retaining walls, basements, and foundations. This latex based formula stops 10psi of water pressure (greater than a wall of water 22 feet high) and reduces radon gas penetration. IAQ 9000 contains an EPA-registered fungicide to help prevent mold from growing on the surface of the cured film. This fast-drying formula may be applied easily with a brush and/or roller on dry surfaces and cleans up easily with soap and water.
Tip: For best results pre-clean and disinfect with a Fiberlock Disinfectant.

