IAQ 2500

Ready To Use Disinfectant

SKU: 8325 Categories: ,

Packaging Types:

5 Gallon
Where to Buy

Description

In situations where a clean water source is not available or onsite mixing is not practical, IAQ 2500 is the perfect choice for hard surface disinfection. This convenient, ready-to-use product is proven effective as a general purpose, non-acid cleaner, fungicide and disinfectant for use in residential and commercial facilities, including homes, schools, office buildings, and retail businesses..

Features

  • Pre-mixed, ready-to-use formula that can be applied straight from the container
  • EPA registered

How to Use

DISINFECTION AND CLEANING

Remove gross filth or heavy soil prior to application of the product. Hold container six to eight inches from surface to be treated. Spray area until it is covered with the solution. Allow product to penetrate and remain wet for 3 minutes. No scrubbing is necessary. Wipe off with a clean cloth, mop or sponge. Fiberlock IAQ 2500 will not leave grit or soap scum. Using approved AOAC test methods (under Good Laboratory Practices), in the presence of 5% blood serum and a three minute contact time, unless otherwise noted, this product kills the following organisms on hard, non-porous, inanimate surfaces.

BACTERICIDAL ACTIVITY

Pseudomonas aeruginosa, (ATCC 15442) Staphylococcus aureus, (ATCC 6538) Salmonella choleraesuis, (ATCC 10708) Escherichia coli, (ATCC 11229) Escherichia coli 0157:H7, (ATCC 43895)

ANTIBIOTIC-RESISTANT BACTERICIDAL ACTIVITY

Methicillin resistant Staphylo-coccus aureus (MRSA), (ATCC 33593) Van-comycin resistant Enterococcus faecalis (VRE), (ATCC 51575) Vancomycin intermediate resistant Staphylococcus aureus (VISA), (CDC Isolate 99287)

TUBERCULOCIDAL ACTIVITY

This product exhibits disinfectant efficacy against Mycobacterium tuberculosis (BCG) at 20°C when the treated surface is allowed to remain wet for 5 minutes.

VIRUCIDAL ACTIVITY

This product, when used on environmental, inanimate hard surfaces exhibits virucidal activity against Norwalk Virus, when the treated surface is allowed to remain wet for 30 seconds. This product, when used on environmental, inanimate hard surfaces exhibits virucidal activity against Human Coronavirus when the treated surface is allowed to remain wet for 2 minutes.

FUNGICIDAL ACTIVITY

Fiberlock IAQ 2500 is fungicidal against the pathogenic fungi Trichophyton mentagrophytes (Athlete’s Foot Fungus) when used with a 10 minute contact time on clean, non-porous, hard surfaces as found in bathrooms, shower stalls, locker rooms, or other areas commonly contacted by bare feet.

MILDEWSTAT

To control mold and mildew on pre-cleaned, hard, nonporous surfaces spray surface to be treated with Fiberlock IAQ 2500, making sure to wet completely. Let air dry. Repeat application at weekly intervals or when mildew growth appears.

STORAGE AND DISPOSAL

DO NOT CONTAMINATE WATER, FOOD, OR FEED BY STORAGE OR DISPOSAL.

PESTICIDE STORAGE

Store in a dry place no lower in temperature than 50°F or higher than 120°F. Container Disposal: Triple rinse (or equivalent). Then offer for recycling or reconditioning, or puncture and dispose of in a sanitary landfill, or incineration, or, if allowed by state and local authorities, by burning. If burned, stay out of smoke.

PESTICIDE DISPOSAL

Pesticide wastes are acutely hazardous. Improper disposal of excess pesticide, spray mixture, or rinsate is a violation of Federal Law. If these wastes cannot be disposed of by use according to label instructions, contact your State Pesticide or Environmental Control Agency, or the Hazardous Waste representative at the nearest EPA Regional Office for guidance.

Safety & Technical Data Sheets