Description
IAQ 6200EZ is a white, tintable mold resistant coating for professional use, that contains a fungistatic agent to resist mold growth on the dry coating surface. IAQ 6200EZ is value engineered with high volum projects in mind. IAQ 6200EZ is a flexible and permeable 100% acrylic water based coating. IAQ 6200EZ has successfully passed both ASTM G-21 and ASTM D-3273 mold resistance testing with the highest possible ratings. IAQ 6200EZ is recommended for use on wood, plaster, wallboard, sheetrock, concrete, masonry block, primed metal and galvanized metal. IAQ 6200EZ can also be used on new structural materials during building construction.
How to Use
SURFACE PREPARATION
Surfaces to be coated must be free of dust, mildew, mold, dirt, grease, loose paint, oil, glue size, calcimine, wax, soap and other surface contamination. Clean mold stained surfaces with Advanced Peroxide Cleaner, or use an EPA registered antimicrobial disinfectant cleaner such as IAQ 2000, IAQ 2500, ShockWave or ShockWave RTU. Patch irregularities with vinyl patching paste or an appropriate patching compound. IAQ 6200EZ is self-priming over bare sheetrock, composition board, ceiling tile and concrete.
WALLBOARD, SHEETROCK, GYPSUM BOARD
Joint cement should be sanded smooth, but avoid abrading the paper.
FERROUS METAL
Clean, then prime with rust inhibiting direct-to-metal primer.
WOOD
Seal knots and stains with stain-blocking primer.
MASONRY BLOCK
Apply block filler if a denser surface is desired.
APPLICATION TOOLS
Airless sprayer: Primary & Recommended Method
• Tip: 0.013”-0.019”
• Pressure: 1800-2400 psi
Roller: for small or confined areas.
• ½” nap synthetic roller
Brush: will require 2 coats.
• Synthetic, nylon, polyester
TINTING
IAQ 6200EZ may be tinted to any off-white or pastel based color. Add up to 2 oz. of universal colorant per gallon. Start with 50% of the tinting formula and adjust as necessary.
PRODUCT APPLICATION
Apply IAQ 6200EZ generously and uniformly by brush, roller, or airless spray (prefered). Apply one coat of IAQ 6200EZ and ensure that the finished surface is properly sealed. To ensure that the finished surface is properly sealed, two-coats may be required on some porous surfaces.
COVERAGE
- Smooth Surfaces- 300-400 sq. ft. per gallon
- Porous Surfaces- 150-300 sq. ft. per gallon
DRYING TIME
- @ 70°F 50% R.H
- To Touch – 1 Hour
- Recoat – 4 Hours
CLEANUP
Clean tools and drippings with warm soapy water before Fiberlock IAQ 6200EZ dries. Dispose of all waste according to all existing local, state and federal regulations.
PRECAUTIONS
Store in a dry place at temperatures between 40°F (4.5°C) and 90°F. (32°C). Stir thoroughly. Do not mix with any other coatings, solvents or colors in oil. The IAQ 6200EZ coating is resistant to mold only on the surface of the coating. No mold resistance claim is made other than to the coating itself. The use of this product does not protect users or others against food-borne or disease-causing bacteria, viruses, germs or other disease-causing organisms. Do not apply when air or surface temperature is below 50°F, or when drying conditions are poor or when surfaces are above a 15% moisture level content. Use adequate ventilation during application. When applying with a sprayer, wear a NIOSH approved respirator with any R, P, N or HE filter. For interior use only.
